position n. 1.位置;方位;地點。 2.處境,情況;狀態,形勢 ...
approximate vt. 1.使接近。 2.接近;走近。 3.近似,約計。 4.模擬。 5.估計。 approximate a solution to a problem 使問題近于解決。 approximate something to perfection 使某物臻于完善。 The total income this year approximates 10,000 dollors. 今年總收入接近一萬元。 approximate the motions of the stars in a planetarium 在天文館中模擬行星的運行情況。 We approximated the distance at 100 miles. 我們估計行程距離為100英里。 vi. 近于。 His income this year approximates to 8,000 dollars. 他今年的收入接近八千美元。 adj. 近似的,大概的。 an approximate account 簡要的說明。 an approximate date 大約的日期。 the approximate estimate 大概的估計。 an approximate number 概數。 an approximate value 近似值。 adv. -ly 大體,大致。
Aims at application , we mainly discuss face detection in two circumstance . ( 1 ) in the gray image , we use difference image in multi - frames , then get the edge of the face , we make the raw - location to ensure the approximate position of the face , next , we use the template of the face to occlude the pseudo face region and get the region which near the exact face region . ( 2 ) use method of two template matching , first , we get the face template from many face average , second , we copy the eye section of the face template then get the eye template 文中首先介紹了圖像預處理的各種方法,重點介紹了圖像分割和人臉檢測定位,針對實際應用的要求,著重處理了兩種情況的人像檢測定位: ( 1 )在灰度圖像下對連續輸入的多幀進行差分,對于得到的邊緣進行處理初步確定人像的大概位置,然后采用模板匹配進行精確定位。 ( 2 )應用雙模板匹配的方法,由多人臉平均得到人臉模板和眼睛模板,在檢測中采取了首先使用尺度相對較小的雙眼模板搜索候選人臉,再用人臉模板匹配進一步篩選候選人臉的方法。
In the second method , wavelet transform is combined with modal transform , and transient travelling - wave signal is used . after three phase signals are decomposed into their modal components , the wavelet transform coefficient of ground mode can be used to identify approximate position of fault , and the wavelet transform coefficient of aerial mode is used for identifying arrival time of traveling - wave 第二種方法將小波變換與模式變換理論結合起來,采用的是暫態行波信號,首先將三相信號轉換成模式分量,零模分量的小波變換系數用于判別故障的大致位置,然后利用線模分量的小波變換系數來確定行波到達時間。