The reason for the emergence of this phenomenon is that the frequency of incident microwave is getting close to the eigenfrequency of the cavity 這是因為此時腔體的本征頻率,近似等于入射波載頻,引起腔體的共振。
I turns out to be that the position and degree of damage can not be well detected only by eigenfrequency , while only can detect if the damage has appeared . however , severe damage can be diagnosed if the modal shape and natural period are used 利用以上指標對試驗構件的損傷進行識別與定位,研究結果表明,僅憑獲取的固有頻率不能準確判斷結構構件的損傷狀態及損傷位置,只能初步判斷結構中是否出現損傷。
The influences of stator ' s teeth on vibrating modal of the linear standing wave usm are discussed in this paper , in which eigenfrequency and wave - shape are analyzed while the position and geometry dimension of stator ' s teeth are changed , and it can give some advice on design for standing wave linear ultrasonic motor 摘要本文對一類直線型駐波超聲電機振子的振動模態進行了系統的分析,討論了定子齒的位置、幾何尺寸對直線型超聲電機的固有頻率、振型的影響,為該類駐波型直線超聲電機的設計提供了理論依據。
Using pro / e ansys fem software , based on results of analyzing fem model , the article discuss the influence to the eigenfrequency of the stator in different dimension parameters of the stator loop , different pzt thickness , the influence of tooth height along circumferential direction on eigenfrequency is analyzed . it offers a foundation for optimum design the structure of the stator . fem equivalent circuit model of the ultrasonic motor has been built 利用pro / e 、 ansys等軟件建立了圓盤定子的有限元模型,通過有限元分析的方法,討論了定子圓盤各個徑向尺寸參數對特征頻率的影響,不同壓電陶瓷厚度對定子特征頻率的影響,以及定子齒的齒高的變化對特征頻率的影響,為馬達結構參數的優化設計提供了依據。