久久久久久人妻精品一区二区三区,国产亚洲精品久久久久5区

TranslationMobile

荷載比
裝料比
裝填比
裝藥率

"loading" in Chinese : n. 1.裝貨。 2.裝載量；重量；載荷；(船只等的)貨 ...
"ratio" in Chinese : n. (pl. ratios) 1.比，比率，比值；比例 ...
"noise loading ratio" in Chinese : 噪聲負載比
"propellant loading ratio" in Chinese : 推進劑裝載比
"ratio of floor loading" in Chinese : 地基系數
"loading" in Chinese : n. 1.裝貨。 2.裝載量；重量；載荷；(船只等的)貨載。 3. 填充物 ...
"no loading" in Chinese : 不停車載客
"t loading" in Chinese : 載重汽車荷載
"t-loading" in Chinese : 載重汽車荷載
"as ratio" in Chinese : 聯想感覺比
"ratio" in Chinese : n. (pl. ratios) 1.比，比率，比值；比例；系數。 2.【經濟 ...
"ratio t" in Chinese : 統計系數與標準誤差比率
"t ratio" in Chinese : 統計系數與標準誤差比率
"a loading area" in Chinese : 裝卸區
"abnormal loading" in Chinese : 異常荷載

Examples

The loading ratio was climbed to 0 . 6 in a relatively short time
在較短的時間內充氫率很容易達到0 . 6 。
Standard guide for determining load ratios for technical rescue systems and equipment
技術救援系統和設備的荷載率測定的標準指南
Load ratio uster
帶負載電壓蝶器
Probe into the dynamic fracture toughness of marble using the energy method in medium load ratio
用能量方法探索測量中等加載速率下大理巖動態起始韌度問題
Influences of load ratio , materials strength and ratio of reinforcement on seismic reliability of beams were analyzed
研究了荷載比值、材料強度等級和配筋率對梁可靠度的影響。
The result of this method agrees well with that estimated by fem . load ratio coefficients a and p are important to calculate vertical stresses
本文分析了、對下臥層附加應力的影響并討論了荷載分配系數、的計算方法。
The axial load ratio influenced the cantilever columns behaviors significant , the larger axial load ratio was , the lower ultimate load and worse ductility was shown
軸壓比在較小的時候可以提高鋼管混凝土的承載力，當軸壓比較大時，其承載力顯著降低，延性也較差。
At a temperature range of the ambient temperature ~ 400 c and 100pa ~ 1000pa pressure we found the optimal condition to improve the loading ratio in palladium wire by gas - loading method
摸索出溫度在室溫400壓力在100pa 1000pa條件下，氣態充氫和提高鈀絲充氫率的條件。
( 3 ) the cfdst beam - columns were tested under constant compressive axial load and cyclic lateral load . the main parameters varied in the tests are axial load ratio and hollow section ratio
( 3 )以空心率和軸壓比為主要變化參數,進行了壓彎構件在往復荷載作用下的試驗研究。
The he - ne laser with the wavelength of 632 . 8nm , when was interacting on the pd wire , which loading ratio is 0 . 6 , we gain the apparent " excess heat " by the excitation
而且，在he - ne激光器發出的波長為632 . 8nm激光的照射作用下，在充氫率為0 . 6時，曾一度觀測出明顯的“過熱”現象。