例句與造句

1. The advantages and the disadvantages of every structure and every flow rate dividing method are analyzed . further requirement of techniques and problems to be investigated are pointed out in this chapter . then it presents a new idea of flow rate dividing method based on pressure decrease sensing and meter - in flow rate feedback control to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads
   第一章緒論綜述了多執行器系統的概念、基本構成和一些分流控制方法，分析了各種分流控制結構和分流控制方法的優缺點，在此基礎上指出了一些所需要進一步研究的問題；接著提出了論文的選題意義和一種基于壓差傳感和執行器進油側流量反饋的分流控制方法來實現大小慣性多執行器流量合理分配的構想。
2. It brings about the problems of low flow - used ratio and bad harmony in flow dividing control when simultaneously operating multi - actuators with different inertia loads . this paper is aimed to solve these problems by method based on pressure decrease sensing and meter - in flow rate feedback control of actuators . in this paper , several important points including theoretical analysis , computer simulation , and experiment study will be explained
   本論文主要針對因執行器所驅動慣性負載的差異而引起流量利用率低和協調性不佳的問題，提出了一種基于壓差傳感和執行器進油側流量反饋的分流控制方法，并進行了相應的理論分析、仿真研究和實驗研究。
3. Then pid flow rate control algorithm is introduced . all experiments made in this chapter are about measuring the valve parameters according to spool positions , single actuator flow rate control by the calculated flow rate feedback control method , free flow rate dividing control under the sufficient pump discharge flow rate situation , proportion flow rate dividing and flow rate dividing based on meter - in flow rate feedback control method under insufficient pump discharge flow rate situation . the results of all experiments proved that the method presented in this thesis is an effective way to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads
   第四章介紹了多執行器復合控制實驗系統和實驗方法；介紹了實驗采用的流量控制的pid算法；并測定了執行器控制閥和閥芯位移相關的系數；做了單個執行器計算流量反饋流量控制、流量足夠情況下多執行器流量任意分配、流量不足情況下多執行器按比例調節流量分配和多執行器進油側流量反饋分流控制實驗；通過實驗說明了論文提出的分流控制方法能實現大小慣性負載復合操作時的合理分流。
4. Chapter 3 gives an introduction to the flow rate dividing principle based on meter - in flow rate feedback control of multi - actuators control system . special analysis about simultaneously operating multi - actuators with different inertia loads is made . finally the results of simulation proved that the new method is an effective way to improve the flow - used ratio when the pump discharge flow rate is insufficient
   第三章介紹了基于執行器進油側流量反饋的分流控制的原理，并針對大小慣性執行器同時起動時采用該分流控制方法進行了具體分析；最后通過仿真說明該分流控制方法能在大小慣性執行器同時起動并在泵輸出流量不足的情況下有效提高泵輸出流量的利用率，并能實現優先級和分流比混合控制。
5. It's difficult to find meter-in in a sentence. 用meter-in造句挺難的